View Single Post
Old 01-08-2001, 10:18 PM
JDUB JDUB is offline
Registered User
Join Date: Apr 2000
Posts: 412
As a recall I had to loosen the exhaust systen on my 1990 190 E 2.6 to get to the center bearing. There is a heat sheild covering the center bearing and the exhaust was in the way on mine. If you need to drop the exhaust, pull up the passenger floor panel and disconnect the O2 sensor wiring.(one wire) Depending on your tool assortment you need some large channel locks or a 41mm (huge) open end wrench to loosen the driveshaft clamping nut. You may have to remove the rear trans mount if you find it difficult to get to the flex disk bolts and nuts. Not too difficult a job.
good luck.
1990 190E 2.6
1996 Grand Voyager 3.3
1985 Mustang GT 5.0 5 SPD
1982 Suzuki GS 750T
Reply With Quote