Its already done. I warmed up the interior of the car to make all the plastic parts "softer", and it came out pretty easily with the hooks. As was stated, just take your time, work out each side little by little, and out it comes. There were four electrical connectors, 2 easily removed, 2 a little more stubborn.
Changed the bulbs I needed to, and everything is fine with the exception of one thing.
I was hoping to be able to remove the outside temp sensor board so that I could re-solder a new bulb into the board, but that bad boy was not coming out. It seemed loose, but it was NOT going to slide out. What do I still need to do to fix that, the NEXT time another bulb burns out??