View Single Post
  #1  
Old 05-25-2005, 09:14 AM
Brian Carlton Brian Carlton is offline
Banned
 
Join Date: May 2002
Location: Blue Point, NY
Posts: 25,396
W126 rear suspension ride height

I posted this in DD and remain without a satisfactory solution:


I've been working on the problem of the low ride height in the back of the SDL for the past several months.

All dimensions will be made from the road to the inside of the fenderwell in the back.

Prior to any modifications, the vehicle would typically have a ride height of 24.50-24.75 inches. This is a pronounced squat in the back.

I changed subframe bushings and differential mount. This increased ride height to 25.25- 25.50 inches. A small improvement, but not enough.

Changed springs using p/n 116 324 08 04.
Installed new 19 mm rubber spring pads.

Took the vehicle for a drive and parked it.

Measured the ride height the following morning: 25.5"
Camber: 1" negative across the tire face (equates to about 3°)

The new springs had no effect on the ride height.



The springs are supposedly OEM and manufactured by Meyle.


In discussion with the supplier (not the dealer), he indicated that this is the only spring that was specified for the 300SDL, as cataloged by Meyle.

Does anyone have any additional info regarding the proper spring and whether Meyle is the OEM supplier?

The attitude of this vehicle is definitely not proper, and the camber seems excessive.
Reply With Quote