It was just evacuated, lines taken off compressor, condensor and evap and lines flushed, then put back together. The only thing that makes sense to me is either the expansion valve metering of the freon is "out of spec but kinda working" or the evap has crap all over it. But if it were the evap, the outlet would be ice cold since the air couldnt get to it, but its warm/ cool. And the pressure would be much lower. I have pinched off the heater water and checked all pods with dash off.
I think the valve is open too much flooding the evap causing higher pressures and less cooling/evaporating of the freon and causing low high side pressures cause its just blowing through the evap.
Like running a car with no thermostat/metering device. It can overheat due to the coolant going through the radiator too quick to let the air cool it.
Maybe Ill just go out and buy a corvette.