I know there is at least one who has adapted his ets (evaporator temperature sensor) as I read his thread of how he was unfortunate/amazed to make a block of ice. Didn't hurt his system, but it has the potential to starve the compressor (not good) so it should be "tuned" carefully. I believe he had it set (ets) at 0 degrees and was going to raise it a bit. ASAMOF what is the compressor cut out temperature on a 201 ets?

I know it's not hard to adjust; I'm just looking for what size resistor for w201 ets. He's close.

__________________
JHaburay

1972 280se 4.5 "princess"
1986 2.3-16v first 100 (099) USA