|
|
|
#1
|
|||
|
|||
How to remove back window - w126 rust problem - 85 300sd
How do you remove the rear window / seal I need to replace the metal on the bottom sill due to rust and water in the trunk.. Will a seal and window and sill from a 87 300sdl fit? I shows as a different part # for seal.
Last edited by badgator; 10-10-2008 at 07:43 AM. Reason: clarification |
#2
|
|||
|
|||
81- 85 w126 window is different than 86+
81- 85 w126 rear glass is different than 86+
|
#3
|
||||
|
||||
let a pro remove it and when you're done, let them put it back in
most dealers have a glass company that does this for them, ask them or an inde for referrals
__________________
1989 300ce smoke silver / brazil, in a constant state of flux ~~~ |
#4
|
||||
|
||||
The glass will fit the same between a Gen 1 and Gen 2. The rubber seal and trim are different.
To remove the glass you need to: 1) remove lower rear seat by two releases at base of seat (seriously) 2) remove upper rear seat, there are three 8mm bolts: one on each side and one in the middle. 3) remove C pillar trim: #1 phillips head screw, then pry front of trim at door seal, then slide upwards to release the rear of the trim. Then disconnect the reading lights. 4) remove upper center trim by pulling forward and disconnect light 5) remove rear platform pocket latches (one for first aid kit the other for storage) with a #2 phillips head screw driver. 6) remove rear platform: lift upward slightly and pull forward. disconnect speaker cable. 7) disconnect defroster power strips, one on each side. 8) from inside, gently pry window seal in and back over frame lip, work all the way around. 9) pull out window. Replacing the window is at least a two person operation - three is better. Here is an excellent series of about 75 pictures on how to perform the task: http://schloerb.smugmug.com/gallery/5283121_5bQoe#321926677_9vR3j There are other pictures mixed in with what you need to see. Here are a couple of samples:
__________________
http://i284.photobucket.com/albums/l...aman/Fleet.jpg Peach Parts W124.128 User Group. 80 280SL 85 300SD 87 300TD 92 300D 2.5 Turbo 92 300TE 4Matic Last edited by pwogaman; 10-13-2008 at 11:18 AM. |
#5
|
|||
|
|||
Cool
Thanks,
Friday I pulled the back glass and seal out took about 15 minutes on a 300sdl -for practice |
#6
|
||||
|
||||
Out is much easier than in. Make sure you have help.
__________________
http://i284.photobucket.com/albums/l...aman/Fleet.jpg Peach Parts W124.128 User Group. 80 280SL 85 300SD 87 300TD 92 300D 2.5 Turbo 92 300TE 4Matic |
#7
|
||||
|
||||
[quote=pwogaman;1991661]The glass will fit the same between a Gen 1 and Gen 2. The rubber seal and trim are different.
Are you sure that they are the same??? I am having a terrible time getting the rear glass for my 85 300Sd. The one that was installed needed to be cut down to fit and the trim popped off on the way home. The early glass was laminated and the newer glass is tempered and I have been told that the defrost wires are in a different place. Thanks Robert |
Bookmarks |
|
|