|
|
|
#1
|
|||
|
|||
bodykit front bumper install question
I acquired a 94 w140 with replica Lorinser front and rear bumpers.
After a foolish mishap, I have to repair the front unit. Who ever installed the kit, in my opinion did a very poor job lining it up. Even went as far as using screws to fasten it into the fenders. I have stripped all the mounting points off the inside of the bumpers in an effort to properly align it to the rest of the car. My question is.... there is some type of epoxy that looks to be used in order to initially fasten the mounts to the fibreglass. Can anyone suggest such a material? My intention is to fasten the stock mounting parts into place, then use some of the epoxy to temperarily hold the bumper to the mounts until I can properly glass them into place. The same thing will have to be done to the rear bumper since is has a 1/2" gap on the passenger side and sits properly on the driverside. Thanks |
Bookmarks |
|
|