|
|
|
#1
|
||||
|
||||
83 300 sd
Previous owner had mounted a very old very sad aftermarket tapedeck into the car. Decided to put in a newer JVC I had laying around. Tried to clean things up a but as I went. PO just wrapped the wires together and duct taped them together. There were only two speaker wires and two speaker grounds so I just connected the wires from the rear speakers of the head unit to the existing speaker wires and all four speakers play. Trouble is as I turn up the volume so I can here sound the face of the head unit starts to flash ans fade with the music and if I turn it up more the stereo cuts out like I am getting a brown out. Is the original wiring not enough power for the unit or am I missing something? I checked the wires before I hooked it up to be sure I was getting power and I had 12.6V. Thank you in advanced for the assistance.
|
#2
|
||||
|
||||
Rewire the entire car. Seriously. Use the switched, constant, ground, and dimmer... then run new speaker wires to new speakers. You'll be pleased then.
__________________
I'm not a doctor, but I'll have a look. '85 300SD 245k '87 300SDL 251k '90 300SEL 326k Six others from BMW, GM, and Ford. Liberty will not descend to a people; a people must raise themselves to liberty.[/IMG] |
#3
|
||||
|
||||
Was a bad ground.
|
#4
|
||||
|
||||
Quote:
|
Bookmarks |
|
|