W126 Stereo upgrade using factory amps, trouble
1990 300SEL W126,
My becker died again after get it refurbed only 2 years ago. I decided to just replace it with an aftermarket head unit. I would rather not go through the trouble of bypassing the amps If I can avoid it. I followed the advice in this thread: http://http://www.peachparts.com/shopforum/car-audio-multimedia/276276-w126-headunit-replacement-keeping-factory-amps.html Where it says how to use the low level output wires and connect them to rca cables to use the factory amps. I believe that I have to connect up the white and yellow wires to the RCA plug ground from the stereo and I also ganged it with the shielding ground (brown wire) but I have lost all of my bass. Funny thing is if I disconnect the brown, yellow and white wires I still get sound but it is really tinny and then when I reconnect them the sound improves but it is still lacking base. Im confused. I guess I don't really understand how the brown shielding wire fits into the puzzle. |
1 Attachment(s)
No lucky yet. Here is a closeup of the part of the wiring I am struggling with. How to I make this set of wires accept a feed from RCA pre-outs?
|
Well, I got exasperated and ran speaker wire from the head unit to the amp locations and tied into the speaker wires there. I did remove the seats to run the wires. I love how these cars were put together.
|
Quote:
|
All times are GMT -4. The time now is 06:41 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website