|
|
|
#1
|
|||
|
|||
Problem: APS 30 installed in W210 turns off?
Hi, I just installed an APS30 in my 2002 E-class wagon but it's not working quite right. Anyone recognize what's going on here:
It works fine with the ignition off, but turns off when I start cranking the engine. If the engine is already running, it can't be turned on until ~45 seconds after key-off. If it's on and I take the key to the run position (#2) without cranking it, it continues to work without turning off. I've noticed when the unit's off, and the parking lights are on, the unit's "on" button illumination goes out a few seconds after starting the engine. So any known cure? If not, any ideas of further tests/resets/measurements that's be useful? Thanks, Rod |
#2
|
|||
|
|||
Fixed! - fuse #10 had blown - I measured the switched supply at A7 and it was dead so I started looking at fuses.
I guess the CANbus was not sending the right signals as the steering wheel buttons were taken out by the fuse. |
Bookmarks |
|
|