|
|
|
#1
|
|||
|
|||
replacing oil cooling hose '85 300sd
I have loosened the hose ends but it will not come out, what other parts do I need to remove to replace the oil cooling holse?
|
#2
|
|||
|
|||
The hose is attached with brackets to the side of the motor.
__________________
Steve Brotherton Continental Imports Gainesville FL Bosch Master, ASE Master, L1 33 years MB technician |
#3
|
|||
|
|||
and
after those are removed
do I need to remove any other parts? the hose is trapped front and rear top and bottom |
#4
|
||||
|
||||
There is a hold down clamp (10mm bolt) just aft of the ac compressor. To make the removal job easier, take masking tape and tape the hose nuts to the end of the hose. This puts the nuts out of your way. BTDT! Do the same with the new ones.
__________________
N. Hodges 1994 S350 1987 300 SDL (for sale) |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|