|
|
|
#1
|
||||
|
||||
where can I get the splined socket for the IP seals?
I'd like to replace the delivery seals on my '87 300SDL within the next couple weeks while I'm also replacing the glow plugs. I'm going to do the o-rings and crush washers since they're cheap. I've done loads of searching and have determined that is probably a cause of my poor cold running.(missing, smoke, knocking). I figured it would be eaiser without the manifold in lace so that's why I'm just going to just go ahead and do them then.
Do you guys have any idea where I could buy or rent that socket from? Thanks David
__________________
_____________________________________________ 2000 Honda Accord V6 137k miles 1972 300SEL 4.5 98k miles _____________________________________________ |
#2
|
|||
|
|||
www.samstagsales.com has about any tool you need for a Mercedes. Excellent quality and original German manufacturers.
__________________
Sam 84 300SD 350K+ miles ( Blue Belle ) |
#3
|
||||
|
||||
Are there any cheaper places? From what I've noticed, Samstag really likes to charge their fair share of pennies.
Thanks David
__________________
_____________________________________________ 2000 Honda Accord V6 137k miles 1972 300SEL 4.5 98k miles _____________________________________________ |
#4
|
||||
|
||||
You are also supposed to replace the little springs while you are in their. I didn't but I didn't know at the time! They look real cheap, can't cost more then a $1 each. Make sure to clean every spec of dirt off the top of the IP, treat the area like you are preforming surgury. I got lucky someone lent me the socket, but it would be a nice tool to have.
__________________
1999 SL500 1969 280SE 2023 Ram 1500 2007 Tiara 3200 |
#5
|
||||
|
||||
If someone wanted to rent mine, I'd take gift certificates? Seriously, send me a PM want'71
__________________
'95 E320 Wagon my favorite road car. '99 E300D wolf in sheeps body, '87 300D Sportline suspension, '79 300TD w/ 617.952 engine at 367,750 and counting! |
#6
|
|||
|
|||
Ebay.
Best Regards, Jim |
#7
|
||||
|
||||
Performance Products also has the tool. Perhaps even Phil can get it for you.
__________________
'02 BMW 325i '85 300D 450k '93 190E 2.6 170k(killed by tree) '08 Ducati Hypermotard 1100S 6k '06 Ducati S2R800 14k(sold) |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
617 Turbo oil return line. Replacing seals | dmorrison | Diesel Discussion | 11 | 04-25-2005 07:53 AM |
wagon door seals different? | odie | Diesel Discussion | 4 | 09-07-2004 09:46 PM |
Torque Wrench & Socket Source For 603 Injector Pump Pressure Valve Seals | ezrider | Diesel Discussion | 4 | 02-18-2003 07:33 PM |
C class radio wiring | marc c | Car Audio and Multimedia | 3 | 08-15-2002 09:28 AM |
Valve seals - the aftermath. | GregS | Diesel Discussion | 5 | 08-29-2001 11:57 PM |