|
|
|
#1
|
||||
|
||||
Replacing the nuts that hold the air cleaner down
Ok, the part I'm talking about is under the air cleaner housing. Theres a rubber mount with a bolt going through it. There are some nuts missing that hold the air cleaner down. I can't seem to find a way to get those little buggers on. What tools or methods have some of you used for the same job?
-Joe
__________________
'81 MB 300SD, '82 MB 300D Turbo (sold/RIP), '04 Lincoln Town Car Ultimate Sooner or later every car falls apart, ours does it later! -German Narrator in a MB Promotion Film about the then brand new W123. |
#2
|
|||
|
|||
H-town,
All the rubber air cleaner mounts I've seen have a flat washer with a screw protrusion molded onto two sides of the rubber mount. Once you attach the 3 rubber mounts on the air cleaner bracket by tightening the 3 nuts on the bottom, the air cleaner is placed on the 3 mounts with the top screws of the mount going thru the 3 holes in the air cleaner and the nuts are then tightened from the top. P E H |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
How to fix wobbly air cleaner? | WannaWagon | Diesel Discussion | 29 | 06-01-2005 05:46 AM |
Curious 300D Air Cleaner Setup | Idahoel | Diesel Discussion | 6 | 09-28-2003 01:45 AM |
Air Cleaner Case Oil | Jtrinidad | Diesel Discussion | 4 | 01-27-2003 07:05 PM |
OIL in my Air Cleaner...? | shawnster | Diesel Discussion | 7 | 06-23-2002 08:35 PM |
Will Alum 240D Air Cleaner Fit on 300D | tcane | Diesel Discussion | 0 | 01-10-2002 07:33 PM |