|
|
|
#1
|
|||
|
|||
Need help
OK gents I need some guidance. I have a couple of recent problems with my 300TD 1985 Yep I learned to ID my vehicle. Anyway hose from self leveling system to the pump from the reservor is leaking....badly. So where do I find the part...Thanks I have dealer phobia. Anywhere else ? I found a deteriorated fitting (oil covered) fitting off the rear side of the injection pump (towards the engine) about mid point, tried to trace it but was lost to the left in a bunch of other lines. What the heck is it's purpose ? Looks like hard plastic vacuum line. How far does your ALDA srew protrude from the holding nut ? Lots of questions and lots of experience here on the forum. Thank you.
|
#2
|
|||
|
|||
I can't offer any specific answers but I would check Fastlane or call them if it doesn't show one online (the hose that's leaking), Phil can usually find stuff like that if you call him. The oily line you refer to may be the one coming from the back of the intake manifold to the ALDA, if it is it probably should be cleaned out along with the banjo bolt coming out of the intake manifold, it let's the ALDA adjust the IP as boost comes up.
__________________
1985 300D Turbo ~225k 2000 F350 (Powerstroke) 4X4, SWB, CC, SRW, 6spd ~148k 1999 International 4900, DT466e (250hp/660 ft/lbs), Allison MD3060 ~73k |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|