Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help

Go Back   PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > Diesel Discussion

LinkBack Thread Tools Display Modes
Old 01-06-2001, 05:23 PM
Posts: n/a
I replaced the rear shaft seal on the transmision of an 84 300 sd. Now i need to put the casing on with a new gasket. What torqe should this be tightened to? The book has only the pan gasket which it says is 14 pounds. That figure seems a little low. thanks for the advise. I am a new member and i already love the help.
thanks mike
Reply With Quote
Old 01-06-2001, 09:00 PM
Registered User
Join Date: Mar 1999
Location: Suwanee, GA, USA
Posts: 4,712
The bolts back there are 8mm, I think, so that torque would be about right... Be sure not to over-tighten the big bolt on the rear of the tranny. I don't remember it off hand, but a good rule of thumb is not past where it was when it came off (where the lock leaves its print).
Donnie Drummonds
Reply With Quote


Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On

Similar Threads
Thread Thread Starter Forum Replies Last Post
1983 300sd $1900.00 !!!! KYCOL Diesel Discussion 0 05-09-2004 03:56 PM
W116 300SD and W126 300SD comparison? ericnguyen Diesel Discussion 11 07-11-2003 01:11 AM
Desperately Seeking a 300SD!! diesellady Diesel Discussion 14 08-28-2002 01:19 PM
specs. on a 1980 300SD, torque, fuel capacity... rickjordan Diesel Discussion 4 11-09-2000 12:01 PM
300SD valve specs....... CJ in RSM, CA Tech Help 1 04-10-1999 12:28 PM

All times are GMT -4. The time now is 06:38 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2018 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page