|
|
|
#1
|
|||
|
|||
I replaced the rear shaft seal on the transmision of an 84 300 sd. Now i need to put the casing on with a new gasket. What torqe should this be tightened to? The book has only the pan gasket which it says is 14 pounds. That figure seems a little low. thanks for the advise. I am a new member and i already love the help.
thanks mike |
#2
|
|||
|
|||
The bolts back there are 8mm, I think, so that torque would be about right... Be sure not to over-tighten the big bolt on the rear of the tranny. I don't remember it off hand, but a good rule of thumb is not past where it was when it came off (where the lock leaves its print).
__________________
Benzmac: Donnie Drummonds ASE CERTIFIED MASTER AUTO TECHNICIAN MERCEDES SPECIALIST 11 YRS |
Bookmarks |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
1983 300sd $1900.00 !!!! | KYCOL | Diesel Discussion | 0 | 05-09-2004 03:56 PM |
W116 300SD and W126 300SD comparison? | ericnguyen | Diesel Discussion | 11 | 07-11-2003 01:11 AM |
Desperately Seeking a 300SD!! | diesellady | Diesel Discussion | 14 | 08-28-2002 01:19 PM |
specs. on a 1980 300SD, torque, fuel capacity... | rickjordan | Diesel Discussion | 4 | 11-09-2000 12:01 PM |
300SD valve specs....... | CJ in RSM, CA | Tech Help | 1 | 04-10-1999 12:28 PM |