|
|
|
#1
|
||||
|
||||
has anyone pulled a tranny from an SDL?
I hope to be pulling my tranny within the next week to replace my rear crank seal and was wondering if there are any special tricks. I plan to just do the seal not the flex discs, etc. Are there any other parts I'll need to replace such as crush washers, etc.?
Thanks David
__________________
_____________________________________________ 2000 Honda Accord V6 137k miles 1972 300SEL 4.5 98k miles _____________________________________________ |
#2
|
||||
|
||||
Mine and the driveshaft will be coming out sometime this June, whenever I get a good week weather wise.
I plan on doing a full write up on the procedure with pics. Pulling the trans looks like a pretty simple job, I would rent a trans jack. If you can use that lift you have access to it will make the job ten times simpler. Don't forget a new trans mount, and I would also the the shifter rod end. They can corroded mines getting pretty bad.
__________________
1999 SL500 1969 280SE 2023 Ram 1500 2007 Tiara 3200 |
#3
|
||||
|
||||
trans mount, I forgot about that. I'll pick one up today when I'm at the dealer getting my gaskets.
Thanks David
__________________
_____________________________________________ 2000 Honda Accord V6 137k miles 1972 300SEL 4.5 98k miles _____________________________________________ |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
83 240D tranny won't shift past 2nd gear. | dmorrison | Tech Help | 16 | 10-31-2018 08:14 PM |
1986 300SDL Question | Marcb | Diesel Discussion | 21 | 02-17-2010 07:17 PM |
tranny removal 84 300DT | almadroog_7 | Diesel Discussion | 3 | 08-29-2004 11:00 PM |
tranny removal (drive shaft) | almadroog_7 | Diesel Discussion | 3 | 08-27-2004 07:46 AM |
Tranny problem | elau | Tech Help | 0 | 02-27-2002 11:24 AM |