Hi all...

I am trying to swap a 84/85 300D Trans into a 83 300SD.

As I have read in past posts, the tail housing is the only difference in the transmission and that the pickup needs to be changed.

In the transmission from the 300D, on the right side of transmission rear section (the case side to which the tail housing bolts), I see an additional hole in the case that does not exist in my 300SD. It looks like it might feed or be fed fluid from (what I think goes in there as it fell into my hands when removing tail housing) a plastic angled tube with a o-ring. My guess is it might be to feed fluid to the gear for the Speedo?

1. What if anything is done with the opening in the swap?

2. I am not clear on what the pickup is and therefore what to change.

Thank you
Don

__________________
1980 300TD-T (82 Turbo and Trans) 159,000 Miles "Jackie-O"
1983 300SD 272,000 Miles "Aristotle"
1987 Jeep Wagoneer Limited - keeps the MB's off the ice and out of the snow
1994 BMW 530it

The plastic tube feeds the gear for the mechanical speedometer. I know there is no need for the lubing when completed because it will be an electronic speedometer. I was worried that if I left the plastic part out or plugged the hole it would affect the fluid pressure in some way, so I trimed the plastic tube to fit with the parts needed for the electronic speedometer and put the tail housing on.

Hope that works.

Don

__________________
1980 300TD-T (82 Turbo and Trans) 159,000 Miles "Jackie-O"
1983 300SD 272,000 Miles "Aristotle"
1987 Jeep Wagoneer Limited - keeps the MB's off the ice and out of the snow
1994 BMW 530it