|
|
|
|
|
#1
08-08-2005, 10:00 AM
|
|||
|
|||
|
W201 axle shafts
Howdy,
While doing a brake job on my '84 190D 2.2 this weekend, I checked out the axle shafts and noticed that one had quite a bit more longitudinal play than the other. That is, I could grab the axle and move it back and forth towards the differential. Is there any spec on how much end play these are supposed to have? No side to side play and the boots look fine. Total play was approx 1/8" or maybe 3/16". Sholin
__________________
What else, '73 MB 280 SEL (Lt Blue) Daily driver: '84 190D 2.2 5 spd. 
|
 |
| Bookmarks |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 4matic question - front axle shafts | belagirl | Tech Help | 4 | 04-19-2005 05:52 PM |
| Question on Axle of w201 2.3 16V | swib | Tech Help | 6 | 03-19-2004 07:57 AM |
| Replacing axle shafts? | rstl2002 | Diesel Discussion | 5 | 06-13-2003 11:44 PM |
| Replaced Axle Shafts w/ Rebuilts But The Noise Persists | SW | Tech Help | 11 | 09-22-2001 09:32 PM |
Linear Mode
