|
|
|
#1
|
|||
|
|||
Rear suspension bushings
So I am to the point of having to replace the bushings on the spring link (what ALLDATA calles it) in the rear of my 87 300TD. I have ordered the parts through NAPA and they have sent me the wrong parts 3 times. Does anyone know where I can get the parts. I have checked here, benzbin, etc etc and cannot find it anywhere.
__________________
Owen 87 300TD 603 I-6 94 Jeep XJ I-6 4.0 (see the pattern) 89 750il seventy-two hundred feet above sea level (kinda cold up here) |
#2
|
|||
|
|||
bushing
Check with Phil @ FastLane on this website. He has a good track record of getting the right part(s) and getting them to you quickly.
|
#3
|
|||
|
|||
There are two bushings on the spring link, an inner and an outer. Here are the part numbers:
Inner: 202-352-00-65 Outer: 220-352-02-27 In either case you'll need special tools to extract and press in the bushings. |
#4
|
||||
|
||||
Special tool number would be nice.
Quote:
Trailing Arm Bushing W126 1985 300SD DIY Special tool number would be nice. Organized MB DIY links post: Tools and Hardware: Organized MB DIY links I have added this thread to: ShopForum > Technical Information and Support > Diesel Discussion Organized MB DIY links post: Suspension: Organized MB DIY links
__________________
ASE Master Mechanic asemastermechanic@juno.com Prototype R&D/testing: Thermal & Aerodynamic System Engineering (TASE) Senior vehicle instrumentation technician. Noise Vibration and Harshness (NVH). Dynamometer. Heat exchanger durability. HV-A/C Climate Control. Vehicle build. Fleet Durability Technical Quality Auditor. Automotive Technical Writer 1985 300SD 1983 300D 1984 190D 2003 Volvo V70 2002 Honda Civic https://www.boldegoist.com/ Last edited by whunter; 01-04-2006 at 10:09 PM. |
#5
|
|||
|
|||
Puller for outer bushing: 202-589-00-43-00
Puller for inner bushing: 129-589-01-43-00 |
#6
|
|||
|
|||
Just an idea......
I am not familiar with the rear suspension of the wagon. If it has the same trailing arm, I used a section of 5/16" all-thread, washers, nuts and large 3/4" drive sockets to press the control arm bushings. Worked like a champ.
__________________
Sam 84 300SD 350K+ miles ( Blue Belle ) |
#7
|
||||
|
||||
Thank you
Quote:
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|