82' 300sd - no low beam driver side
The low beam on the drivers side doesnt work. It will however 'randomly' work.
All other lights work fine, *the high beam works fine on that side, just tired of blinding everyone* So I just installed some European head lights, and would'nt you know it, the problem still exists. This is the 'yellow' wire in plug cluster, I see it runs to the fuse box. Do you think this is wire problem *run a new wire?*, switch, or something else? Thanks! -brad |
Check the fuse. Number 6(red) is for the left side low beam, I don't know off the top of my head the number for the right.
|
sounds more
like a continuity issue (wow i like the sound of that word). i would suspect a loose wire at the socket or a bad prong acceptor "thingie" (darn, ruined my excellent vocabulary thing i had going).
been there, done that. tom w |
bdeely, Even after you check the fuse, Cut your lights on and be sure you have 12 volts at each end of your fuse, keep us posted...gene2
|
I had the same thing happen. Solder joint at the connecting pin was broken. Re-soldered and all is working normally again! It is easier to solder if you remove the entire cast hopusing from the car.
|
Thanks!
I'll try the fuse this weekend, check wire etc.
Whats wierd is, if i turn on the lights, turn on the fog lights, hit the brights, then return to low beam, all is well. Wierd. |
Just remembered...also had a bad solder joint at the switch in the stalk on the steering column. That one left both low beams out!
|
All times are GMT -4. The time now is 04:53 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website