|
Pressure Plate Bolt Torque
What is the torque spec on the six bolts for the pressure plate on a 240D?
It's an '80 (w123/OM615) if it makes a difference. Someone asked the same question in 2002 and no one answered it. |
It's been 4 years and still nobody knows???
|
haynes manual states
initial torque 30 to 40Nm or 22 to 30 Ft-lbs
and Final step Rotate bolt head an additional 90 to 100* John |
nope, that is for the flywheel./crankshaft bolts.
brb John |
hmm
odd. the manual does not state this spec... the instrustions for changing disc says to tourque the PP to specified tourque, but no mention of where to find that spec.
maybe when I am awake better I can find it. |
I found the clutch cover bolt spec. that MAY be it..
odd thing is in the instructions it states Pressure plate, not clutch cover, but here you go.
24Nm or 18Ft-lbs:1blank: |
Thanks!
|
since I cannot find exact tourque specs,
I would put blue loctite on each bolt, and tighten until full face contact, in star pattern, then snug up a little. these are small bolts, DO NOT over tighten them.
John |
The pressure plate is the clutch plate. Thanks for the numbers vstech, this thread has always been invaluable to me :)
|
| All times are GMT -4. The time now is 07:41 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website