Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > Diesel Discussion

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 03-22-2001, 08:37 AM
NIC
Guest
 
Posts: n/a
This post is for those of you who drive an old mercedes that has a slight to moderate, rythmic vibration in the drivetrain (that tends to be worse when power applied).

For six months I tried to fix a vibration in my 300CD (138k miles). Replaced many parts (motor/transmission/rear end mounts, rebuilt and balanced main driveshaft, new center bearing, new flex discs, repacked front wheel bearings). None of this solved problem. Finally I replaced half-axles with rebuilt units from Fast Lane ($200 each with exchange). Vibration now gone.

Message is check out the half-shafts. My car has been carefully driven and maintained so my guess is many other older mercedes need these axles replaced. Makes driving at speed so much more pleasant.

Nic in SC

Reply With Quote
  #2  
Old 03-25-2001, 06:52 PM
Richard Tucker
Guest
 
Posts: n/a
Vibration in rear end

I have an 1982 300 D. I am having a similar problem. Slowing down from crusing speed at appox. 20 mph I have a "rattle" that appears to come from the differential. Also on acceleration if I hold at about 30 mph I have the same sensation. As I accelerate the rattle or vibration tends to fade away.

It's driving me nuts ! I have had it in the shop three times and nothing can be found. Is this similar to you situation? It may me an answer to quite my ride.

R. Tucker
1982 300 D 91,000
Reply With Quote
  #3  
Old 03-25-2001, 09:08 PM
240Joe's Avatar
Registered User
 
Join Date: Nov 2000
Posts: 525
I had a similar problem with my 87 300 sdl. I had it to 2 shops, one an independent that thought it was the driveshaft, and the dealer, who....thought is was everything and started replacing things...to no avail.

My problem turned out to be a bad left side half shaft. You could grab it and move it back and forth.

Drive trains are difficult to troubleshoot. It could be the shaft itself out of balance (if someone worked on the shaft before), the center carrier bearing, the flex disks, half shafts, and even the rearend.

Make sure you don't have a wheel out of balance. Drive train problems are usually found when under power, so if you coast and have it, it probably a wheel.

My problem would only occur at 75MPH plus. That makes it difficult to troubleshoot for a dealer in the suburbs. It's rather dangerous to put it on the rack and run the drive train up to speed.

After all that worthless chat, I would try to pull and tug on each half shaft and see if you notice any different between them.

If one is loose, I would order one from the MB salvage yards on the net...used ones are a lot cheaper, and "swap it out".

Joe

Reply With Quote
  #4  
Old 03-26-2001, 07:31 AM
NIC
Guest
 
Posts: n/a
Richard,

I think Joe's right, troubleshooting a drive train problem is hard. Could be anything. I had to "renew" most everything in my drivetrain before solving my vibration completely. Wasn't any one item. I think these old diesel Benz's just want to vibrate and to get really smooth ride, you have to take a comprehensive approach. Worth the effort though - mine now rides great.

I personally wouldn't buy a used half shaft. Rebuilt ones from FastLane are $200 and you can spend as little as $129 at local Advance Auto.

Here's my path to smooth ride:

- new motor mounts/transmission mount
- new center bearing and flex discs on drive shaft
- balance drive shaft and rebuild universal joint
- new differential mount
- rebuilt half shafts

Total cost approx $1,200 using local indie shop. DIY'ers can save a lot

Nic
'85 300CD @138K
Reply With Quote
  #5  
Old 03-26-2001, 12:53 PM
Registered User
 
Join Date: Feb 2001
Location: Midwest, USA
Posts: 171
My '79 300SD has developed a "duh-duh-duh-duh-duh-duh..." when I go up a hill or when I hit exactly 37 MPH. It is getting worse, and I have not ventured under the car yet. I am hoping for it to be a flex disc, or center bearing. I would think an axle shaft would be noisy all of the time? I will report back on my findings.
Reply With Quote
  #6  
Old 04-03-2001, 07:57 PM
Richard Tucker
Guest
 
Posts: n/a
Thanks for all of your help. I now have several suggestions to pose to the service techs.
Reply With Quote
  #7  
Old 04-22-2001, 11:43 AM
Richard Tucker
Guest
 
Posts: n/a
update

I recently took my vehicle to a great local shop. As several of you thought it might be, it seems to be the left half shaft. Going into the shop this week for a full analysis , but definitely the left half shaft to be replaced. Thanks for all the advice. I'll let you know how it goes.
Reply With Quote
  #8  
Old 05-07-2001, 09:47 PM
Richard Tucker
Guest
 
Posts: n/a
Repairs completed

As NIC thought, it was the half shafts. I had them replaced and it drives like a new car ! Thanks for all the help.
Reply With Quote
  #9  
Old 05-08-2001, 12:26 AM
Zoonhollis's Avatar
Diesel Fanatic
 
Join Date: Jun 2000
Location: Cary, NC
Posts: 551
I found a half-shaft at a local salvage yard for $75, and replaced it myself this past weekend. The old one had a missing boot, and was way overdue to be swapped.

As mentioned in this thread, the difference is very pleasing. Before, when traveling at 60mph plus, images in my rear view mirror were fuzzy and "out of focus." After replacing the shaft (about a three hour job), the ride is much smoother, and the mirror no longer vibrates.

I'm sure it's hit and miss with these junk parts, but I guess I lucked out. Now to replace the other side...

__________________
Matt
------
1995 E300 Diesel (Die Blau Frau)
Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On


Similar Threads
Thread Thread Starter Forum Replies Last Post
Vibration and now locked up front brake W126 BMJR Tech Help 6 08-10-2003 03:51 PM
400E Vibration, What to do Next?? timreid Tech Help 9 10-03-2002 11:45 AM
Vibration at high rpms, 300CD 240 Ed Mercedes-Benz Wheels & Tires 0 01-17-2002 05:55 AM
'84 380SL Engine & Drivetrain Vibration Igor Tech Help 0 05-15-2000 06:20 PM
Drivetrain Vibration lkh Tech Help 1 08-11-1999 09:19 PM



All times are GMT -4. The time now is 09:52 AM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page