|
|
|
#1
|
||||
|
||||
Parts for the SDL topend, help me see what I'm missing...
Okay gang, going to start ordering parts for the SDL to keep it going. Here's what I have so far:
1 - 6030106220, SDL headgasket kit 7 - 6039900310, SDL headbolts 6 - 6039900110, SDL headbolts 13 -6039900210, SDL headbolts 1 - 6010500416, SDL tensioner guide 1 - 6010520516, SDL lower guide rail 1 - 6010520316, SDL upper guide rail 1 - 0239978447, SDL front main seal I can't find the part number for the prechambers. Should I replace the lifters? I have the valve guides, seals, and such on the way for the head. Turbocharger is getting rebuilt too while it's down. Also that side oil pan gasket part number too... Also I can't find the part number for the front cover gasket (if there is one). I have a new front main coming too. What am I leaving out? Yay, headgasket gone on my SDL
__________________
I'm not a doctor, but I'll have a look. '85 300SD 245k '87 300SDL 251k '90 300SEL 326k Six others from BMW, GM, and Ford. Liberty will not descend to a people; a people must raise themselves to liberty.[/IMG] |
#2
|
||||
|
||||
Oh, and valve springs too.
__________________
I'm not a doctor, but I'll have a look. '85 300SD 245k '87 300SDL 251k '90 300SEL 326k Six others from BMW, GM, and Ford. Liberty will not descend to a people; a people must raise themselves to liberty.[/IMG] |
#3
|
||||
|
||||
If you're fitting a -17- or newer head you'll need the longer bolts from the head into the timing chain cover.
If you're going as deep as the tensioner rail, you're very close to the oil pump chain. A timing chain retention pin or two in case you damage one removing it? It'll never be easier to get to the thermostat. Valve gover gasket, crossover pipe gasket, intake manifold gasket. Exhaust manifold can stay attached but if you remove it you'll need a gasket set and new copper nuts. Glow plugs. Sixto ... stay tuned |
#4
|
|||
|
|||
is this a good time to pull the injection pump and redo the gaskets or seals or whatever the heck is leaking in the bottom of mine?
|
#5
|
||||
|
||||
I'll be rebuilding my No 18, so I'll keep the bolts from that motor.
Does the oil pump have a chain and tensioner like the M116/7 motors? Only issue I see with that is I'd have to drop the main oil pan...
__________________
I'm not a doctor, but I'll have a look. '85 300SD 245k '87 300SDL 251k '90 300SEL 326k Six others from BMW, GM, and Ford. Liberty will not descend to a people; a people must raise themselves to liberty.[/IMG] |
#6
|
||||
|
||||
Those plastic fuel lines too.
__________________
I'm not a doctor, but I'll have a look. '85 300SD 245k '87 300SDL 251k '90 300SEL 326k Six others from BMW, GM, and Ford. Liberty will not descend to a people; a people must raise themselves to liberty.[/IMG] |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|