|
|
|
#16
|
||||
|
||||
anyone have an idea on how much?
__________________
1983 Toyota Tercel 4WD Wagon - 1984 Mercedes-Benz 300SD 4-Speed(My Car!) 2005 C230 Kompressor 6-Speed Manual
|
#17
|
||||
|
||||
If I could get a piece of threaded rod the proper size, about $20-25ish shipped.
depending on how you'd like it made. Add more for brass or alumn. CRS is usually what I find. on that note, anyone know the thread size?
__________________
-1983 VW Rabbit LS Diesel (5speed, VNT/Giles build) |
#18
|
||||
|
||||
You'll hog out the rod?
The thread is M24 x ??. I measured 4mm over 4 peaks so that would be a pitch of 1.33. I've never heard of that pitch. Is there a better/correct way to measure? Sixto 93 300SD |
#19
|
||||
|
||||
Quote:
Yes, I'll hog the rod out (drill, bore) using a split-nut, as to not mar the threads; and cut a square at the top (kinda like a pipe cap)
__________________
-1983 VW Rabbit LS Diesel (5speed, VNT/Giles build) |
#20
|
||||
|
||||
I thought about that but the ALDA has less than 5mm of threads. I can see how a pitch gauge could be a little off. If there's no 1.33mm pitch in the gauge then problem solved
Maybe it's M24 x 1.5 just to put it in common numbers. Won't PVC work? Get an inch of 3/4" sched 40, run an M24 x 1.5 die on one end and put a cap on the other end. Finger tight should be fine but you can file some wrench flats. Sixto 93 300SD |
#21
|
||||
|
||||
Quote:
Nylon would even be cool; as you could dye it...
__________________
-1983 VW Rabbit LS Diesel (5speed, VNT/Giles build) |
Bookmarks |
|
|