Parts Catalog Accessories Catalog How To Articles Tech Forums
Call Pelican Parts at 888-280-7799
Shopping Cart Cart | Project List | Order Status | Help



Go Back   PeachParts Mercedes-Benz Forum > Mercedes-Benz Tech Information and Support > Diesel Discussion

Reply
 
LinkBack Thread Tools Display Modes
  #1  
Old 02-17-2007, 12:35 PM
Registered User
 
Join Date: Aug 2006
Location: Washington, DC
Posts: 23
Coolant Leaks / Power Loss 1987 300D

Hello all,

I'm writing about two problems with my car that seem to be linked, as far as when they occur. I would really appreciate any help in understanding what is happening.

Issue #1: Leaking Coolant
My 300D leaks coolant intermittently. It was fine the first 6 months I owned the car, but recently started dropping coolant, and I've put almost a gallon in to replace the lost coolant. Sometimes after driving ~40 miles my low coolant light would come back on. However, for about a tank of gas it leaked none--until today.

I've looked all over the engine and found three sources of the leak. These are the upper / lower radiator hose (I tightened the clips on those two hoses), and where the hose to the heat exchanger leaves the engine block (approximately underneath where the air intake for the second cylinder from the firewall meets the cylinder head). I don't know how to tighten this one, as it is a metal-to-metal junction. Can anyone tell me more about this junction and what to do about a leak there?

Also, this has only occurred when it is cold out (I'm in DC) but I'm reluctant to blame it 100% on the cold as it was not leaking last week when it was colder than it is today. Can cold have an effect on the integrity of the cooling system?

Issue #2 Intermittent Lack of Power
The other issue with my car is a lack of power. The car sometimes can't seem to get past ~2100rpm when I try to accelerate. If I really mash the pedal, it will sometimes feel like it "breaks through" the hesitation and start making power again. Almost as if the turbo is stuck, and then spins up, or fuel is stuck, and then flows easily. I'm not sure if turbos, or diesel fule systems have such behavior.

This has only happened when the coolant is leaking (not sure if there's any connection beyond coincidence).

I will add that my cooling system has no pressure in it this morning now that the engine is completely cold, so I do not suspect the dreaded head crack.


--Thanks, I really appreciate your help!!

--Matt

Reply With Quote
  #2  
Old 02-17-2007, 12:52 PM
sixto's Avatar
smoke gets in your eyes
 
Join Date: Jun 2000
Location: Eastern TN
Posts: 20,841
The coolant fitting at the back of the head has a thick o-ring. There's a circlip holding the coolant line to the head. Along the circumference of the circlip there's a hoop you can hook with a pick to pull off the circlip. Then the line will pull out of the head so you can replace the o-ring. It's the same o-ring as used in the heat exchanger line attached behind the water pump, described as water pump o-ring in FastLane. You can check with Phil to be sure.

It's difficult to see a water pump leak in these engines.

Sounds like it's time for new fuel filters and maybe a dose of Diesel Purge.

Sixto
93 300SD 3.0
Reply With Quote
  #3  
Old 02-17-2007, 01:01 PM
Registered User
 
Join Date: Aug 2006
Location: Washington, DC
Posts: 23
Thanks for the reply. I'll look into the coolant fitting to the block.

I actually just had my fuel filters replaced two weeks ago in conjunction with the replacement of my fuel pre-heater, which was leaking. My shop (Mitch Carr's) had thought that should fix the loss of power, and it did, for a time, but now it's back.

My pre-filter currently looks sparkling clean so I'm certain they do not need replacing again.
Reply With Quote
  #4  
Old 02-17-2007, 01:03 PM
sixto's Avatar
smoke gets in your eyes
 
Join Date: Jun 2000
Location: Eastern TN
Posts: 20,841
Remove the fuel filler cap and see if there's a strong rush of air. Seems to be a lot of that going around. Inadequate fuel tank venting I mean.

Sixto
93 300SD 3.0

Reply With Quote
Reply

Bookmarks

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is On
Trackbacks are On
Pingbacks are On
Refbacks are On




All times are GMT -4. The time now is 12:13 PM.


Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website -    DMCA Registered Agent Contact Page