|
|
|
#1
|
||||
|
||||
w124 300d Turbo 603 misses a little when started
Hi guys,
My 603 engine misses just a bit when I first start. My glows are on about 60 seconds before the relay turns off so it's definitely getting a good glow and it's not super cold this morning in Mid Missouri. I'd say 40 F or so. But the same has happened at around 55 to 60 degrees F. This seems not right to me. All 6 glow plugs measure ok (.8 ohms to 1 ohm each). I replaced the 2 bad ones (one open circuit the other 15 ohms). It's much better since I did that but man it's just not instantly smooth like I'd have hoped for. Any ideas? Thanks! Nick
__________________
-E300d '99 350k -Suburban '93 220k -TDI Jetta '03 350k Sold -F250 '96 7.3 -Dodge Ram 12V -E320 '95 200k -E320 Wagon 1994 155k -300d Turbo '87 187k miles -E320 1994 200k -300d Turbo '84 245k (sold to Dan62) -300d Turbo '84 180k -300sd '80 300k -7.3 Powerstroke Diesel 15P Van 500k+ miles -190d '89 Non Turbo 2.5 5cyl 240k (my first MB) Tom's Imports of Columbia MO Ruined the IP in changing leaky delivery valve O-Rings - Refused to stand behind his work. Mid-MO MB drivers-AVOID Tom's. |
#2
|
||||
|
||||
Is that from the relay...
where the wires begin or the plugs directly??
Double check the Ohm scale is zeroed, the last I remember the FM- 0.6 Ohm is a healthy plug. Also, store brand (other than Bosch or Beru) might not be best in these engines.
__________________
1987 300D (230,000 mi on a #14 head-watching the temp gauge and keeping the ghost in the machine) Raleigh NC - Home of deep fried sushi! Last edited by C Sean Watts; 02-21-2007 at 09:55 AM. Reason: forgot |
#3
|
|||
|
|||
check for air
Hi,
I had the same issues. After replacing the lift pump and bypassing the fuel heater even cold starts are instantly perfect (nearly no smoke) After a minute or so little smoke is visible and at 800-1000 rpm i have such misses. The prefilter is collecting air and it is the time when this air is reaching the IP. Air causes misses and idle smoke! Greets Tom |
Bookmarks |
|
|