|
|
|
#1
|
||||
|
||||
SPecial Tool Question
In the ETM, in the throttle control section for 116.120 chassis throttle linkage adjustments.
there is this special adjusting sleeve, and I would like to know the approximate dimensions so I can properly and accurately adjust my linkages... thanks!
__________________
RIP: 80 300SD RIP: 79 450SEL 2002 E430 4matic (212,000km) 2002 ML500 'sport' ____________________________ FACEBOOK: PANZER450 |
#2
|
||||
|
||||
Yep....
__________________
Did you just pass my 740 at 200 kmh in a 300SD????? 1978 300SD 'Phil' - 1,315,853 Miles And Counting - 1, 317,885 as of 12/27/2012 - 1,333,000 as of 05/10/2013, 1,337,850 as of July 15, 2013, 1,339,000 as of August 13, 2013 100,000 miles since June 2005 Overhaul - Sold January 25th, 2014 After 1,344,246 Miles & 20 Years of Ownership |
#3
|
||||
|
||||
Anyone?????
__________________
Did you just pass my 740 at 200 kmh in a 300SD????? 1978 300SD 'Phil' - 1,315,853 Miles And Counting - 1, 317,885 as of 12/27/2012 - 1,333,000 as of 05/10/2013, 1,337,850 as of July 15, 2013, 1,339,000 as of August 13, 2013 100,000 miles since June 2005 Overhaul - Sold January 25th, 2014 After 1,344,246 Miles & 20 Years of Ownership |
#4
|
||||
|
||||
I don't know the answer but you could make your own approximate dimensions from the picture - assuming you know on to which part the special tool is slipped on: Measure the bit it goes on to and assume a clearance fit. Then scale up the dimensions from the picture you attached in post #1.
__________________
1992 W201 190E 1.8 171,000 km - Daily driver 1981 W123 300D ~ 100,000 miles / 160,000 km - project car stripped to the bone 1965 Land Rover Series 2a Station Wagon CIS recovery therapy! 1961 Volvo PV544 Bare metal rat rod-ish thing I'm here to chat about cars and to help others - I'm not here "to always be right" like an internet warrior Don't leave that there - I'll take it to bits! |
Bookmarks |
|
|