Trans Problems. - Want Move In Drive?
I have repaired the vaccum switch, modulater. But if you let the car sit for a few days, you to keep reving the engine , and eventually it starts moving. After it waems it runs fair. I have been trying to set tyhe pressure, but cannot get anything on the pressure port. I have a 1981 300D with a 722.118 trans. I cahnged the filter and fluid too. What is going on? A pump going out? Thanks for any help.
|
sounds like its low on fluid, check the fluid while the car is RUNNING and WARM
|
same issue
My pressure was a little low, I adjusted it up 3psi to the proper level then replaced the service bolt and now have ZERO fluid pressure - level is fine. Can this be a bad modulator (please, please) or the pump has suddenly gone out when I wasn't even driving it. It was running on jackstands to adjust. Any further adjustments to the turn screw in the modulater make absolutely no difference. I find it hard to believe than anything suddenly jumped in there and plugged the filter.
|
Quote:
|
I'm testing on the port next to the modulator. I was at 42psi, but now nothing. Pump or modulator, you think?
|
All times are GMT -4. The time now is 01:54 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website