|
|
|
|
|
#1
11-07-2007, 08:50 AM
|
|||
|
|||
|
603 fuel flow rate
Hello,
What is the fuel flow rate on a W126(300SDL)? Thanks A
__________________
1987 300SDL 187,000 miles 
|
|
#2
11-07-2007, 09:24 AM
|
|||
|
|||
|
I estimate that the rate at idle is approx. .4 gallons per hour.
The rate at maximum power is approx. 8 gallons per hour. Please use these as approximations because I have not done an actual measurement.
|
|
#3
11-07-2007, 11:00 AM
|
||||
|
||||
|
Can't be much, its not that big of an engine.
If you are asking because you want to install an aftermarket filter for WVO use, well any Racor or similer should be enough.
__________________
1999 SL500 1969 280SE 2023 Ram 1500 2007 Tiara 3200
|
|
#4
11-07-2007, 01:23 PM
|
|||
|
|||
|
psychic?
HatterasGuy,
You must be psychic. Actually I am running Bio and want to put a secondary filter/water remover in line to make sure no water gets to the IP. So I did not know if I would need a boost pump or not to move the the bio through the 2nd filter. Thanks A
__________________
1987 300SDL 187,000 miles
|
|
#5
11-07-2007, 01:40 PM
|
||||
|
||||
|
Its a commen question.
 Not sure if you would need to help the delivery pump, another filter shouldn't add to much backpressure.
__________________
1999 SL500 1969 280SE 2023 Ram 1500 2007 Tiara 3200
|
|
#6
11-07-2007, 08:47 PM
|
||||
|
||||
|
Go with a heated Racor 500FG with the 5micron (500SM) element, can have a water-in-filter light too. Racor also makes a vacuum/pressure gauge for the setup.
__________________
 Gone to the dark side - Jeff
|
 |
| Bookmarks |
|
|
Linear Mode
