|
|
|
#1
|
||||
|
||||
changing glow plugs
I am trying to change the glow plugs in my 1991 300d. I read in other threads that it is easier to remove the air intake to get to the plugs. Do I need a special torx wrench or can I do it with a regular wrench and sockets?
__________________
Save the planet |
#2
|
|||
|
|||
torx. i don't remember what one but it is on the small side. go get a mulli sized set and it will have it.
__________________
-Trevor OBK #12 1980 300SD 333,XXX miles - Totaled 1986 Mazda RX-7 212,XXX miles - impounded and auctioned off 2005 Jeep Liberty CRD Limited 33,000- SEGR, Provent, Fumoto |
#3
|
||||
|
||||
It is probably going to be a week-end job. I have to go buy the set first. I was looking at the glow plugs and I was able to reach three of them. I think that it is possible to remove them with a deep socket but the two remaining will definitely need to have the intake removed. thanks
__________________
Save the planet |
#4
|
||||
|
||||
intake crossover removal
5mm hex
|
Bookmarks |
|
|