B2 Piston install problems

[jaysvw]

Ok, so I am working on getting this B2 piston installed in my 84 300SD. However I am having a bit of a problem. I cant get the old piston out. I have the cover off and the rear trans mount bracket disconnected, the trans is sitting lower, just not low enough to get the old piston out.

Any ideas?

Thanks

[DeliveryValve]

You'll need to unbolt the center support bearing for the drive shaft. (which may involve unbolting the driveshaft pan) This should allow you to lower the transmission further.

[300Dinoburner]

You'll also have to use a piece of wood to wedge the trans over to the left to get enough room to pull the piston all the way out. It is a tight fit, but it can be done. Read Russell's great tutorial at DieselGiant.com. Good luck.

[blindwolf]

jack up the pass side rear off the ground, the use a wedge to push the tranny to the left. Jacking the chasis up will give you the room you need.