|
|
|
#1
|
||||
|
||||
93 300 sd bulb out indicator'
Is there a way to bypass the bulb out indicator light ? can it be done at the sockett where the bulb is missing ??? by adding a resistor in line to replace the bulb ? I am running a seprate relay for head lamps and need 1 of the stock head lamp socketts for control voltage. thanks J
|
#2
|
||||
|
||||
Maybe I don't understand the situation but why not just remove the warning bulb?
Sixto 87 300D |
#3
|
||||
|
||||
Does your car use the big lamp monitor relay like the older cars? If so just get a wiring diagram, disconnect the power going to that relay for the high and low beams, and use those wires for the triggers for your relays. Then the system can still monitor the other lamps on the car.
-Jason
__________________
1991 350SDL. 230,000 miles (new motor @ 150,000). Blown head gasket Tesla Model 3. 205,000 miles. Been to 48 states! Past: A fleet of VW TDIs.... including a V10,a Dieselgate Passat, and 2 ECOdiesels. 2014 Cadillac ELR 2013 Fiat 500E. |
#4
|
||||
|
||||
Thats what I wanted to know, but isnt disconecting the wires just like having no bulbs ??
|
#5
|
||||
|
||||
As I understand it the system works like this:
battery --> fuse --> light switch --> bulb monitor --> bulb --> ground If you disconnect the "signal" before it gets to the bulb monitor, it doesn't know the switch is turned on. -J
__________________
1991 350SDL. 230,000 miles (new motor @ 150,000). Blown head gasket Tesla Model 3. 205,000 miles. Been to 48 states! Past: A fleet of VW TDIs.... including a V10,a Dieselgate Passat, and 2 ECOdiesels. 2014 Cadillac ELR 2013 Fiat 500E. |
Bookmarks |
|
|