|
|
|
#1
|
||||
|
||||
Om617.952 after valve adjustment.
I was just wondering what its supposed to sound like after the adjustment. When I went to tighten the valves I checked the clearance to start off and I could barely slip the .05 mm guage bewteen the CAM LOBE and LIFTER with the Lobe's pointy end 12oclock from the lifter. (or are you supposed to measure it with the pointy end down?) It looked like pointy end was up in the manual photograph so a picture is worth a thousand words right? Anyways. Got done with it all exhaust valves at .35 and intake at .1 mm (Thats what the manual said.) It ran good its just the valve noise is more prevalent than before. (I'm not sure if thats the right word. Its been getting fine mileage, little; if any; oil consumption, fine acceleration (even better with the ac turned off and the alternator belt breaks). I've only run it 20 or so miles after the adjustment with an average speed of 45-50.
The questions are: 1. What is the engine supposed to sound like after a valve adjustment 2.What is "coking of injectors" and how do you prevent this? 3.When running WVO and after a valve adjustment what should the timing be set at/to?
__________________
'84 300D w/ 120,___ I wish I had money to buy new shocks. :-( |
#2
|
|||
|
|||
The lobes should be directly opposed to the highest point of the lifter, which I would say gets you at about a 1 o'clock position. Engine should sound smooth with regular clickety clack, but no nailing. Do a search on "coking" and you'll find a bunch of stuff. If you're running veggie, then you're at a high risk of coking injectors. Basically, from what I understand, it's the sugars, free fatty acids and monoglycerides burning in the chamber. I've heard that ip should be set 2 deg differential, meaning 26 deg for the 617. Good luck
__________________
1998 E300D, 287k, barely broken in. |
#3
|
||||
|
||||
Valves tend to get tighter as the seats wear (thus making less noise) so it's reasonable for an engine with properly-set valves to make more noise (lifter clicking) than it did before. Your before-measurements confirm that the valves were indeed tight.
__________________
"Buster" in the '95 Our all-Diesel family 1996 E300D (W210) . .338,000 miles Wife's car 2005 E320 CDI . . 113,000 miles My car Santa Rosa population 176,762 (2022) Total. . . . . . . . . . . . 627,762 "Oh lord won't you buy me a Mercedes Benz." -- Janis Joplin, October 1, 1970 |
Bookmarks |
|
|