|
|
|
|
|
#1
07-21-2008, 09:17 AM
|
||||
|
||||
|
Transmission question(not what you think)
I'm fairly experienced with the working of an engine, but not so much with the working of a transmission(besides how to shift, etc.)
I have a moderate amount of machining experience(enough to get in trouble). In the fall I will have access to a machine shop with mills, lathes, and a few CNC's In order to attach a non-Mercedes standard transmission to a 617, what types of adapters would be needed? Obviously a plate to allow for the housings to mate, but beyond that I don't know. What would be a good transmission to toss in?
__________________
$60 OM617 Blank Exhaust Flanges $110 OM606 Blank Exhaust Flanges No merc at the moment 
|
|
#2
07-21-2008, 09:20 AM
|
||||
|
||||
|
you will need a flywheel to bolt up to the crankshaft, and a clutch disk to mate to the spline on the tranny input shaft.
some form of clutch actuator will be needed as well. the MB original is hydrolic, so you will need a pedal assembly from a 240 to fit in there.
__________________
John HAUL AWAY, OR CRUSHED CARS!!! HELP ME keep the cars out of the crusher! A/C Thread "as I ride with my a/c on... I have fond memories of sweaty oily saturdays and spewing R12 into the air. THANKS for all you do! My drivers: 1987 190D 2.5Turbo 1987 190D 2.5Turbo 1987 190D 2.5-5SPEED!!!  1987 300TD 1987 300TD 1994GMC 2500 6.5Turbo truck... I had to put the ladder somewhere!
|
 |
| Bookmarks |
|
|
Linear Mode
