|
|
|
|
|
#2
08-04-2008, 06:45 PM
|
||||
|
||||
Between the manifold halves or the one in the downpipe?
__________________
I'm not a doctor, but I'll have a look.  '85 300SD 245k '87 300SDL 251k '90 300SEL 326k Six others from BMW, GM, and Ford. Liberty will not descend to a people; a people must raise themselves to liberty.[/IMG] 
|
|
#4
08-04-2008, 07:27 PM
|
||||
|
||||
|
Quote:
Oh you're in for a fun time then!
__________________
I'm not a doctor, but I'll have a look. '85 300SD 245k '87 300SDL 251k '90 300SEL 326k Six others from BMW, GM, and Ford. Liberty will not descend to a people; a people must raise themselves to liberty.[/IMG]
|
|
#6
08-04-2008, 07:40 PM
|
||||
|
||||
|
Look where it's at... turbo has to come out as you have to get the manifold off the head.
__________________
I'm not a doctor, but I'll have a look. '85 300SD 245k '87 300SDL 251k '90 300SEL 326k Six others from BMW, GM, and Ford. Liberty will not descend to a people; a people must raise themselves to liberty.[/IMG]
|
|
#7
08-04-2008, 09:38 PM
|
|||
|
|||
|
One member of the forum was considering a shortcut, do not know if it will work. Cut thru the flexible joint, remove nuts on front exhaust manifold and remove. Remove studs that held manifold. Slot new studs to accept flat screwdriver. Install inner and outer flex joint parts and clamps. Hold exhaust manifold against head, screw in studs. Replace nuts.
|
 |
| Bookmarks |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
