|
|
|
#1
|
||||
|
||||
location of oil pressure sensor 603
does anyone know where the oil pressure sensor is located on this engine.
|
#2
|
||||
|
||||
It is right under the oil filter housing, right above the starter. Their is one black wire coming off it.
__________________
1999 SL500 1969 280SE 2023 Ram 1500 2007 Tiara 3200 |
#3
|
||||
|
||||
ok thanks.i must have disturbed it recently whilst removing and cleaning the fuel thermostat.right now the needle will intermittantly drop to zero and back again.im just not looking forward to going back in there again.
|
#4
|
|||
|
|||
The easiest access to it (for me) was from under the car, just behind the driver's front wheel. It is screwed into the lower rear section of the oil filter cannister, at the bottom of the cannister. Mine had to be replaced, because as soon as you turned the key it registered 3 bar. Don't know why anyone would let it go to that extent - I can't stand not knowing about oil pressure, even an idiot light is better than a non-functional gauge.
Fortunately it has really good pressure - but I like to read it. Ken300D
__________________
-------------------------- 1982 300D at 351K miles 1984 300SD at 217K miles 1987 300D at 370K miles |
#5
|
|||
|
|||
I know, i know, old thread revival. But I'd like to install an aftermarket oil pressure sensor I have that is currently installed on my 4runner---I don't trust my Mercedes one at all since it is so jumpy.
Does anyone know what the thread pitch is? |
Bookmarks |
|
|