Intake not going back on 300SDL
I had a hard time getting the intake manifold lined back up. There is a plastic piece that lines up on the underside of the intake on three of the holes and I could not get the hex screws all the way back in on those 3 holes. I can only assume it is leaking where those 3 screws are not lined up. Can I just pull the plastic piece aside and tighten the screws back down?
A |
Brian are you out there?
|
Can you post a picture?
|
Quote:
Would like to do one this winter.........so, I'll be listening. |
I have had mine off several times but I can't picture what he is talking about.
|
I will see if I can get a pic tomorrow.
A |
My guess is the brackets for the glow harness are getting in the way. The brackets go above the manifold flanges to be retained by the manifold bolts. They do make access to the bolts awkward but I don't recall it being that difficult. It might be more helpful to provide aquaman0001 with pictures of how everything looks installed.
Sixto 87 300D |
4 Attachment(s)
Here are some from when I did the GP's and sealed a bunch of leaks last winter.
|
All times are GMT -4. The time now is 10:43 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website