Took a 0-60 video of my 300SD today....
I was out and about for a while today, so I whipped out the crappy cell phone camera and took a video of my car doing a 0-60. It seems to be about 14ish seconds....however, the test was slightly uphill, and I had junk in the trunk and back seat, 3/4 tank of fuel....and it was raining....so not optimal conditions. I bet I could get a 12.5 to 13 on level ground with all the junk out of my car on a dry day.The white thing behind the wood on my dash is a piece of paper....the wood backing is separated and vibrates (really annoyingly) so the paper stops the vibration. :o I'll glue it eventually....
I also have my bowden cable set to shift a bit earlier.... Enjoy the horrible resolution. :D http://www.youtube.com/watch?v=DyVk1jRHgXs Now I just need to take one of our 300E....that'd make this look reeeal slow. :D |
Nobody even viewed it? :o Sigh.
|
Your 1st to 2nd shift is way too early.
|
Quote:
If I really jam it to the floor (which I don't think I was) it will hold 1st to about 3500-4000..... |
Looks good.However I manually shift at 4500 when racing.
|
Looks more like 15.5 seconds to me. ;)
Tighten that Bowden cable! The gauntlet has been thrown, I'll run my SD today and get a video. |
My time was probably far from optimal. Ideally I'd have a third arm so I could manually shift it all the way....hold 1st and 2nd real long, then use third the rest of the way.....I'll try again sometime with someone else operating the camera. :D
|
I think your transmission is slipping. I can't really tell, but thought I should ask the question just cuz.;)
|
Quote:
|
Have you checked your speedometer for accuracy?
Mine reads five over at all speeds. Helps that 0-60 quite a bit. |
Quote:
|
yeah, well, no one likes it when you gloathttp://www.peachparts.com/shopforum/...ons/icon10.gif
|
It looks so much faster with an 80mph speedo :)
|
Quote:
|
here's a 0-70 on my 300SD the video is a couple years old, BONE STOCK
http://www.youtube.com/watch?v=A69OtIsbkDw I ll do one tomorrow with my current mod's straight pipe, boost controller boost gauge, tranny adjusted for high rpm shifting, egr deleted, black box removed and the dreded HOT AIR INTAKE |
All times are GMT -4. The time now is 09:49 PM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website