Who can tell me what else this shift rod end came in?
 

It came out of my 1980 300GD with a 5-speed. I broke it trying to adjust the shift rod length after a shifter rebuild. 2nd question... who has one you will sell it to me? This goes at the shifter end of the shift-rod.

http://tad.grosvenor.org/gallery/d/5...ter-broken.jpg

-Tad

looks like it might be similar to the ones the 16 valve 190's use.

see if this looks right?

looks the same as the 240D 4spd ends.

Yea It's not clear where my transmission came from. It's behind an om617 and is a 5-speed Getrag. It has the later G shift pattern (Reverse to the left of 2nd). Sean @ EuroTruck Importers is getting me one of the link ends. It's probably the same as the one EPC shows for whatever vehicle you looked up. This has been about a $300 shifter rebuild. Oof.

I may end up getting a 240D shifter at this point so I have more spare parts to work with. Thanks.

-Tad

240 shifter wont have any parts you need for a 5spd. but the rod ends are pretty much the same for all I have seen. some are hollowed out like the one you have and some are solid but they are pretty much interchangable

And they are special order from Germany.....

as a separate part, yes, but i'd bet you can buy any old '77-95 shifter linkage they have in stock in the states and voila you now have two ends in stock without waiting forever.

or just go to the jy