|
|
|
#1
|
|||
|
|||
rocker arm hex head bolt size?
trying to take the rocker arms off so that I can perform a valve stem seal kit replacement. this is a 0617 diesel engine (84 300DT). 8MM hex head drive seems a bit "loose" though it fits. could it be a 9MM hex head drive?
|
#2
|
||||
|
||||
Im pretty sure I used a 8mm or when I did my valve stem seals.
__________________
1985 300TD Turbo Euro-wagon 1979 280CE 225,200 miles 1985 300D Turbo 264,000 miles 1976 240D 190,000 miles 1979 300TD 220,000 GONE but not forgotten 1976 300D 195,300 miles 1983 300D Turbo 175,000 miles http://i42.photobucket.com/albums/e3...e485-1-2-1.jpg |
#3
|
|||
|
|||
the bolts seem to be on fairly tight. is it ok to spray a lubricant, i.e. WD-40 or PCB bolt blaster on the bolt to loosen it up?
|
#4
|
||||
|
||||
Yeah mine were tight too, I doubt that PB blaster or WD-40 will help, but you can try it. Just don't fill up the motor with the stuff, wipe off the the extra.
__________________
1985 300TD Turbo Euro-wagon 1979 280CE 225,200 miles 1985 300D Turbo 264,000 miles 1976 240D 190,000 miles 1979 300TD 220,000 GONE but not forgotten 1976 300D 195,300 miles 1983 300D Turbo 175,000 miles http://i42.photobucket.com/albums/e3...e485-1-2-1.jpg |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|