Good news or still bad news.
Well found out my head is warped. This is due to overheating. ? Would be has anyone else ran into this & the head was the only problem with low compression ,or was lower & messed up too ?
My leakdown pointed to the head as the problem & was right(good news),no air from lower end through dipstick. Cylinder walls look fine no grooving.piston tops look fine. Just have to get another head for it instead of getting this one redone.
Wiithout putting it all back together was going to but new head on & ck compression again before putting rest together. I really do not want to mess with pistons if I do not have to. Any & all thoughts are always aprreciated. Thanks. Rob