|
|
|
#1
|
||||
|
||||
Trans output shaft hex socket?
Where is it possible to find the hex socket to remove the retaining nut from the rear yoke of a 1984 transmission?
Thanks, Ian
__________________
Regards, Ian White 1995 E300 Diesel w124 OM606 2014 E550 w212 M278 biturbo 2001 BMW 740i E38 M62 (past) 1981 300SD w126 OM617 (past) |
#2
|
||||
|
||||
I made one from a chunk of pipe, cant remember the diameter, The last time I needed it, it wasn't skookem enough, but it worked once and was easy to make Maybe schedule 80 next time, or spring for the right tool.
__________________
1985 Euro 240D 5 spd 140K 1979 240D 5 spd, 40K on engine rebuild 1994 Dodge/Cummins, 5 spd, 121K 1964 Allice Chalmers D15 tractor 2014 Kubota L3800 tractor 1964 VW bug "Lifes too short to drive a boring car" |
#3
|
||||
|
||||
46mm open end crow's foot, I imagine it will take you some time to locate one, as you need a torque reading with it.
Pricey.
__________________
83 SD 84 CD |
#4
|
||||
|
||||
Anyone know where I can locate an MB tool? I only need it to swap rear housings....
__________________
Regards, Ian White 1995 E300 Diesel w124 OM606 2014 E550 w212 M278 biturbo 2001 BMW 740i E38 M62 (past) 1981 300SD w126 OM617 (past) |
#5
|
||||
|
||||
Anyone?
__________________
Regards, Ian White 1995 E300 Diesel w124 OM606 2014 E550 w212 M278 biturbo 2001 BMW 740i E38 M62 (past) 1981 300SD w126 OM617 (past) |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|