|
|
|
#1
|
|||
|
|||
1981 300d window switch wires - $25 challenge
I will pay $25 via check or paypal to whoever can conquor this challenge.
I have a 1981 300D. When simply removing the left hand side window switch, I popped open the connector for (I think) the left rear window and also the safety switch. I need to know how to reconnect them. I've seen wiring diagrams but the color codes just don't match my wires. I'm stumped. So I'm turning to you. I have all info including pictures to help with this challenge. Here are the facts: 1. PIC ATTACHED: The switch itself has 8 connections. 3 for front, 2 in the middle for the safety switch, then 3 for the back. From top to bottom in the attached picture, the connections are numbered as follows: (6,7,8) (2,blank) (5,3,4) 2. The plug that is in tact I believe is for the front left window. It's 3 wires are green, black, and red. 3. PIC ATTACHED: I have 5 wires dangling: pink/black, brown, white/red, green/brown, and green/black. 4. PIC ATTACHED: The connector that popped open has numbers inside. 5,1,2,3,4 is how the holes are numbered. The challenge: WHERE THE "F" DO MY 5 DANGLING WIRES GO??? ZC |
#2
|
||||
|
||||
Just curious, why did you pop open the connector and remove the wires? I can take my console apart and give you the color codes/ wire location from my 83, which is probably the same.
__________________
85 300D turbo pristine w 157k when purchased 161K now 83 300 D turbo 297K runs great. SOLD! 83 240D 4 spd manual- parted out then junked |
#3
|
|||
|
|||
The two "brown" ones go to the safety switch (which locks out the rear window switch), they can hook up either way on the two pins.
|
#4
|
|||
|
|||
This was something I didn't do on purpose. It snagged on something, popped open and all the wires popped out. Not sure I could do it again if I tried.
|
#5
|
|||
|
|||
Terminal 1 on the console switch connects to term 3 on the rear door switch.
Terminal 2 on the console switch connects to term 7 on the rear door switch. Terminal 3 on the console switch should be the only wire with power when disconnected/key on. (Probably the red/white.) The wire to terminal 4 should have continuity to ground. The remaining wire goes on terminal 5 and connects to terminal 4 on rear door switch. |
#6
|
|||
|
|||
Quote:
|
#7
|
||||
|
||||
i think what he's saying is pop the rear door switch out and see which wire goes where.
__________________
1984 300TD "MAX" 303K+ still going... fast '70 Chevelle 200k+ home built Shovelhead chopper |
#8
|
||||
|
||||
Ok the terminals on the switch are numbered.
Match them up like this: Red/White #6 Green/Black #7 black/pink #8 Then the brown wire and the brown/green wire go to the child saftey locks.
__________________
1985 300TD Turbo Euro-wagon 1979 280CE 225,200 miles 1985 300D Turbo 264,000 miles 1976 240D 190,000 miles 1979 300TD 220,000 GONE but not forgotten 1976 300D 195,300 miles 1983 300D Turbo 175,000 miles http://i42.photobucket.com/albums/e3...e485-1-2-1.jpg |
#9
|
|||
|
|||
In that case, this is actually very helpful and I wish I had thought to do this myself...
|
#10
|
|||
|
|||
Quote:
Will hopefully owe you $25 tomorrow... zc |
#11
|
|||
|
|||
Quote:
Thanks again for the straightforward answer. Message me your paypal address or somewhere else I can gladly pay up the $25 I promised. ZC |
Bookmarks |
|
|