|
|
|
#16
|
|||
|
|||
Making progress, but
I have everything loose and the exhaust manifold comes off of the head, but the thing that I circled in the picture (wastegate?) hits on the body before the manifold is clear of the studs.
Do I need to remove that thing? If yes, does it need a gasket? also the Flex pipe is cracked, but I ground off the old flex section from the upper pipe and I am looking for a universal flex section that I can weld in. I found one at autozone, a braided section, but the ID was 2 1/4" and a tiny bit too small. they have a 2 3/8" ID flexible one, but it seemed light duty and didn't have solid (non flex) pipe ends. |
#17
|
||||
|
||||
Quote:
__________________
Jim |
#18
|
|||
|
|||
Dumb question:
Do I need to remove the intake manifold before or with the exhaust manifold? I just noticed that it is Loose with 1 nut only left. |
#19
|
||||
|
||||
with
__________________
Jim |
#20
|
|||
|
|||
Thanks - It's out finally - I did have to jack up that side of the engine a little.
|
Bookmarks |
Thread Tools | |
Display Modes | |
|
|