|
|
|
#1
|
||||
|
||||
remove backrest motor without removing the seat(W126)?
After replacing a broken switch and cleaning all connections, I've decided to replace the backrest motor on my passenger side seat. I took off the back seat panel and saw the motor in the lower right hand corner. If I unbolt the seat and slide it back 10 inches will I be able to get that motor out, or do I need to remove the entire seat from the car in order to access a bolt or two from the front of the seat? I'm going to try to get a motor at P-N-P tomorrow. Thanks
__________________
'81 300SD Last edited by otto huber; 05-27-2011 at 01:52 AM. |
#2
|
||||
|
||||
For those of you who are curious to know; I figured out how the motor is attached while at the junkyard. There are three phillips screws holding the motor on the side of the seat. It looks as if you could do the job inside the car, but you will have to unbolt everything in order to get easy access.
__________________
'81 300SD |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|