|
|
|
#1
|
|||
|
|||
1985 300SD seat switch
Hello to all. I am trying to get my drivers seat to move back. The tilt motor and the back incline works sometimes. I need to know how to remove the knobs without breaking them so that I can check power. Can some one tell me how to do this? I cannot find it on the DiYs. I am also going to need to remove the door panel to check the window motor and regulator. Thanks in advance. Jack
|
#2
|
|||
|
|||
The knobs just pull off the stalks on the switch.
If you are patient and have a lot of time, you can remove the switch from the door, dismantle it, and rebuild it. However, be very careful when you take it apart as it has a bunch of springs and balls that are inside. All must get back to their original places. Personally, I just get a new one...........it's not worth the aggravation. |
#3
|
|||
|
|||
If you take the door panel off remember that you pull up to remove it not towards you.
__________________
85 300 SD ~ 115K 82 500 SEC Euro ??K 78 450SL 164K |
Bookmarks |
Thread Tools | |
Display Modes | |
|
|