PeachParts Mercedes-Benz Forum

PeachParts Mercedes-Benz Forum (http://www.peachparts.com/shopforum/)
-   Diesel Discussion (http://www.peachparts.com/shopforum/diesel-discussion/)
-   -   Front struts, bump stops and bellows (http://www.peachparts.com/shopforum/diesel-discussion/312691-front-struts-bump-stops-bellows.html)

1987-300TD 02-10-2012 05:51 PM

Front struts, bump stops and bellows
 
I am going to be replacing my front struts in my 87 300TDT. I have purchased "sport" struts. To that end, I am wondering if I still need the strut bump stop and the strut bellows.

I can see the bump stop at the top of the strut but there appears to be no bellow on the front struts. Do I want the bellows? Do I need the strut bump stop as I am installing "sport" struts?

I am also replacing the strut mounts as mine are being destroyed. I will upload pictures over the weekend...

Thank You for Any Advice!!!

glenn

sixto 02-10-2012 06:26 PM

I say get both. Your car came with bellows, as you call them. Either they were left out the last time the struts were serviced or they disintegrated. Are you asking if you should install or replace the bump stops? You might have to trim the bump stops if you're lowering the car.

Sixto
87 300D

whunter 02-10-2012 07:02 PM

Answer
 
Install them, unless you are lowering the vehicle.

.

1987-300TD 02-12-2012 12:33 AM

Not Lowering
 
As I am not lowering my girl, I have ordered both parts! Thank You for sharing your knowledge and experience...

glenn

MBeige 02-12-2012 12:51 AM

There are different types of bump stops for different types of ride height on the W124.

http://www.w124performance.com/image...p_buffers2.jpg

1987-300TD 02-13-2012 01:06 AM

Bump Stops
 
Thank You for the information MBeige! I have ordered a new set from Peach parts. :-) I am amazed at the breath of knowledge on this list...

BTW, your name came up regarding headlights. I just started a new post about my stolen front turn signal. If you could share some insight there, I would appreciate it! :-)

TIA,
glenn

MBeige 02-13-2012 01:39 AM

You're welcome!

The same info I posted helped me source the correct p/n for the 190E bump stops I needed. Just passing it forward :)


All times are GMT -4. The time now is 02:40 PM.

Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2025, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website