Black vacuum line from injection pump??
I'm working on the 1984 300DT. When pulling a new oil gauge pressure line through the fire wall, I accidentally loosened a black vacuum line. Under the hood, the line comes from the top of the injection pump and then travels through the firewall and connects somewhere. Does anyone have any
ideas where this black vacuum lines connects? Thanks! |
It's just the vent line for the vacuum system. It goes into the cabin to source "clean" air.
You didn't knock it off of anything. |
Quote:
|
Quote:
:mad: |
Some how I kinda think he will know real quickly if he screws that up !
|
I use a flare nut wrench to back up the oil gauge while tightening the
actual oil gauge line using a 10mm.....I learned my lesson the hard way (diesel oil soaked floor board, blue jeans and brand new boots...expensive lesson). |
Quote:
|
Quote:
then, I had to source an oil pressure gauge which required a lot of time and effort; I actually purchased a back up unit in case I make the same stupid mistake. |
Quote:
I suppose my question is whether the gauge actually needs so much torque to prevent any leakage from the fitting? These fittings have a tapered seat and seal with relatively low torque. The forces within the fitting itself are very high despite the low torque from the wrench. |
Quote:
|
All times are GMT -4. The time now is 05:24 AM. |
Powered by vBulletin® Version 3.8.7
Copyright ©2000 - 2024, vBulletin Solutions, Inc.
Search Engine Optimization by vBSEO 3.6.0
Copyright 2024 Pelican Parts, LLC - Posts may be archived for display on the Peach Parts or Pelican Parts Website