|
|
|
#1
|
||||
|
||||
300TD HVAC...issue?
I have an '85 300TD, and...well, I lost my favorite flashlight down this hole:
Question is: Do I have any hope of getting it back? What would be involved in taking everything apart enough to do that, if it's even possible? Thanks! -Rog |
#2
|
||||
|
||||
you can take the side panel off, and then disconnect the plastic vent from the duct and hope the light didn't roll into the duct that goes under the seats... if it did, you'll need to pull the seat to get it out...
__________________
John HAUL AWAY, OR CRUSHED CARS!!! HELP ME keep the cars out of the crusher! A/C Thread "as I ride with my a/c on... I have fond memories of sweaty oily saturdays and spewing R12 into the air. THANKS for all you do! My drivers: 1987 190D 2.5Turbo 1987 190D 2.5Turbo 1987 190D 2.5-5SPEED!!! 1987 300TD 1987 300TD 1994GMC 2500 6.5Turbo truck... I had to put the ladder somewhere! |
#3
|
||||
|
||||
Hey thanks, that doesn't sound too bad. Removing the seat would be okay since I do need to stiffen it up a bit.
It's just hard to tell what all needs to be removed. I'm used to having a Bentley manual for my other cars, but it looks like they never made one for these? -Rog |
#4
|
|||
|
|||
Removing the seat isn`t really very difficult.
On the side of the rear hump, pop off the black cover. remove the 10mm bolt. There are two 10mm bolts that mount the seat to at the front. There are two 10mm bolts that mount the seat at the rear of the seat track. There might be the wire/plug under the seat for the seat belt buzzer. You will have to move the seat forward/back to expose the bolts, and you might have to use the side lever for the elevation, seems like I had to use it to expose the rear bolts. Charlie
__________________
there were three HP ratings on the OM616... 1) Not much power 2) Even less power 3) Not nearly enough power!! 240D w/auto Anyone that thinks a 240D is slow drives too fast. 80 240D Naturally Exasperated, 4-Spd 388k DD 150mph spedo 3:58 Diff We are advised to NOT judge ALL Muslims by the actions of a few lunatics, but we are encouraged to judge ALL gun owners by the actions of a few lunatics. Funny how that works |
#5
|
||||
|
||||
Sorry, I meant that it wasn't clear just by looking as to what to remove to get to the vent system. I've removed the seat before...
Mercedes made most things easy to get to, but they also did a good job of hiding how things attach. -Rog |
#6
|
||||
|
||||
I believe you have to loosen the console to get that side panel off without damage. There are little clips that hold the carpeted piece to the console and dash. The stuff the capet is glued to isn't very strong.
You'll also have to remove the kick panel under the steering column.
__________________
1981 300TD "The Green Lantern" 1980 300TD 1983 300D Euro "China Cat" |
#7
|
||||
|
||||
Great, I will have to tackle that the next time it's halfway decent outside.
It would be funny if it's still shining... -Rog |
Bookmarks |
|
|